Futaba gyro 520 manual

 · FUTABA GY Manuals Rotate the helicopter manaul the nose moves to the left and watch the rudder servo. Do not tie the soft rubber line . The operating parameters of the Futaba GY gyro can be set and changed from a PC by using this software. Since the Futaba CIU-2/CIU-3 USB adapter and power supply (receiver battery or 5V power source) are necessary, procure them beforehand and place into the state in which the CIU-2/CIU-3 is operated properly from the PC.  · Futaba gyro gy manual · FUTABA GY Manuals. The gyro will repeat a ‘1 blink’. Move full left and full right and verify you do not hear the servo strain from binding. Watch the light on hy gyro, when you rotate the helicopter the light will blink fast either blue or red. If everything was okay then the light on the gyro will momentarily.

FUTABA GY Manuals. When you power up the gyro for the first time you should have the tail servo disconnected. The black wires will be away from the labels. If the gyro is set for the wrong direction the helicopter will spin extremely fast as soon as it gets mxnual on the skids. 4/7/ AM. Y www.doorway.ru GY INSTALLATION The gyro should be mounted on a rigid platform, at least 6in [mm] away from a Nitro Engine. It is not necessary to mount the gyro near. FUTABA GY Manuals. The gyro will repeat a ‘1 blink’. Move full left and full right and verify you do not hear the servo strain from binding. Watch the light on hy gyro, when you rotate the helicopter the light will blink fast either blue or red. If everything was okay then the light on the gyro will momentarily change to violet.

Futaba GY Heading Hold Gyro, instruction manual, one each 13" (mm) lead with red connectors and lead with black connectors two sections of sensor tape. Main Forum - Helicopter Talk > Futaba GY problems I believe using analog mode has caused me to have a less than perfect tail setup. INCLUDES: Futaba GY Heading Hold Gyro, instruction manual, one each 13″ (mm) lead with red connectors and lead with black connectors.